XTR Flexi Plate with Textured ULTEM PEI - Sovol SV08 - 355 x 355
Couldn't load pickup availability
Product Details
Fits: Sovol SV08 and VORON Design 350 V2
(Please see full printer list below on the 'Fits & Contents' tab)
Our Textured PEI Flexi Plates in the XTR (or eXTReme version) start with our thicker 0.6mm high chromium spring steel to better resist the peel forces of edge-to-edge prints or high shrinkage filaments. They are then electrostatically powder painted with authentic ULTEM™ brand PEI from Sabic, and kiln-baked for exceptional durability. The Flexi Plate has a double-sided textured PEI coating leaving a pronounced finish on the bottom of your print.
Compatible with the Wham Bam Magnetic Base (not included), this Flexi Plate is ideal for a variety of filaments, including PLA, TPU, PETG, and ABS. For additional adhesion with challenging materials like Nylon, use purple glue sticks or Magigoo, which wash off easily.
Printer Fits:
• Sovol SV08
• VORON Design 350 V2
May fit:
• Sovol SV03
• Zortrax M300
If you have a printer similar to the one described above and believe our solution could work for your printer, please follow our easy instructions on measuring your build plate. Let us know if your printer matches our specifications or is even close! We’d love to hear about it, and you might even receive a discount on Wham Bam® merchandise for your efforts. Click here for more info.
- 1 XTR Powder Painted Ultem™ PEI Flexi Plate
- 355 x 355 mm
- Flexi Plate 0.6 mm
- ULTEM™ PEI Build Surface 0.12 mm, on each side
Note: You should already have a magnet or clips installed on your printer, as this is needed to use a Flexi Plate.
If your machine has automatic bed leveling, run the leveling process and set your gap such that the first layer is well squished. For more details on achieving the right first layer squish, refer to this bed leveling guide.
If your printer uses manual leveling, follow the same guide for instructions on the leveling process.
Cleaning Before & After prints
After every print, we suggest wiping with isopropyl alcohol and a fresh paper towel. If you have small bits, such as purge lines, stuck to the surface you can try with a steel spatula with corners rounded to carefully remove these. Do not use Acetone as this will damage the surface.
Longterm Contaminants cleaning:
Should the PEI ever lose its grip, you may also try common dish detergent or vinegar and clean with water as these help break fats added to filaments with effects. You can also lightly pass over the plate with 600 grit wet dry sandpaper to revitalize, then clean with IPA and a fresh paper towel.
Full support info can be found on our support page.
