Wham Bam
Wham Bam
  • Home
  • Our Products
    • Flexible Build System
    • HotBox
    • MUTANT
    • FBS for Resin
    • Slap Mat
  • Shop
  • Blog
  • Support
  • More
    • Home
    • Our Products
      • Flexible Build System
      • HotBox
      • MUTANT
      • FBS for Resin
      • Slap Mat
    • Shop
    • Blog
    • Support
  • Home
  • Our Products
    • Flexible Build System
    • HotBox
    • MUTANT
    • FBS for Resin
    • Slap Mat
  • Shop
  • Blog
  • Support

HotBox Support

The setup and installation of the new Wham Bam HotBox is quick and easy, unfold the sides and position the top and front into place. Then zip each side closed and that's it, your 3d printer enclosure is built! Watch this video to see an example of install on a Creality Ender 3.

Downloads

Resin HotBox Instructions (pdf)Download

If your spools are not spinning freely you have 3 options:

  1. Add an extender to the spool mount:   https://www.thingiverse.com/thing:5353214  This lifts spool holders (Creality Ender 3 Style) so the spool can pass over the Wham Bam HotBox. Print at any height just by changing the Z scale in the slicer.   Measure to estimate how much clearance is needed for the spool holder and adjust the Z scale in yours slicer. You will need some M5 screws to compensate for the added extender and depending on the height you printed the extender you will need to add that to the original length of the M5 screw which is 8mm. 
  2. Mount your spool to the inside of the HotBox on the lower portion of the printer frame.
  3. Print a mobile spool holder like this and sit it on top of the HotBox:  https://www.thingiverse.com/thing:3490081


STL downloads created for the HotBox

HotBox Exhaust Fan


HotBox Enclosure Exhaust


HotBox Feet 


HotBox Feet Alternate


IKEA Lack Table Brackets


Prusa Filament Riser


Creality Ender 3 S1 Pro - HotBox Conversion Set

Helpful STL downloads

Printer mount for the Cloud


Tabletop spool holder


Ender 3 Filament Roller Guide

More HotBox Videos

Check out our YouTube playlist of videos for the HotBox.

Copyright © 2018 Wham Bam - All Rights Reserved.  

Contact Us At: Info@WhamBamSystems.com

  • Home
  • Flexible Build System
  • HotBox
  • MUTANT
  • FBS for Resin
  • Slap Mat
  • Shop
  • Blog
  • Support
  • FAQ
  • Install
  • Instructional Videos
  • Contact Us

Cookie Policy

This website uses cookies. By continuing to use this site, you accept our use of cookies.

Accept & Close