1 3

Flexi Plate with Pre-Installed PEX Build Surface - 377 x 370 - Creality Ender 5 Plus

$76.00 USD
$76.00 USD
Sale Sold out
Shipping calculated at checkout.
In stock (11 units), ready to be shipped

Description

Size: 377mm x 370mm / 14.8" x 14.6"

fits: Creality Ender 5 Plus

We start with our original high chromium spring steel Flexi Plates and pre-install our Wham Bam PEX Build Surface made from a specially formulated polymer with a higher melt point than PEI that attracts most any filament without damaging the sheet. Prints easily pop off once cooled and flexed. Works perfectly with your Wham Bam magnetic base, not included. 

View the full chart of filament settings on PEX

*Attention: It is the buyer’s responsibility to be sure the size selected will work on your machine. Measure your bed, do not rely on build volume. Wham Bam is not responsible for mistaken order sizes.

**It is the buyer’s responsibility to pay any taxes and import duties. No refunds of uncollected customs packages.

Customer Reviews

Based on 1 review
100%
(1)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
A
Anonymous
PEX preinstalled Flexi Plate

The plate works as expected. PETG is my favorite filament, and I followed the instructions from the video. I did not have steel wool, so I substituted 2000 grit wet/dry sandpaper to scuff the surface. Using soapy water and a sanding block is the best way of doing this. Printing at 240 degrees and 80 degrees bed temperatures with no damage. Prints are easily removed and have a glossy smooth finish. I wish I had started using PEX sooner. This by far the best bed plate I have used.